Note: inch standard is required. This Park Tool set is designed for removal or - in combination with the HHP-2 or HHP-3 press tool (not included) – installation of Pressfit bottom bracket cups. You pull it through the bearing and the flared ends then pop … The BBT-90.3 also includes two installation bushings #669. Although I do not have extensive experience with this tool, the few times I have used it went off without a hitch. See details - Park Tool BBT-90.3 Press Fit BB Tool - BBT-90.3 Park Tool BBT-90.3 Bearing Tool Set. Use the bushing in conjunction with an HHP-2 or HHP-3 Bearing Cup Press to press the bearings into the frame. As the included remover expands behind the bearing once the tool is in place, the bearing is removed by tapping on the top cap with a hammer. The tool we were discussing for bottom bracket removal is Park's BBT-90.3, which is a metal tube, about 3/4" in diameter with one end cut cut lengthwise into quarter sections and then flared outward. The BBT-90.3 also includes two installation bushings #669. The set also includes two installation bushings #668 designedfor the … Removes and installs the bearings and bearing units used in BB86, BB90, BB92, Shimano, SRAM, GXP, Race Face and other press fit bottom bracket systems using a 24mm spindle; Park Tool BBT-30.3 Bottom Bracket Tool Set for BB30 The Park Tool BBT-30.3 Bottom Bracket Tool Set is designed for installation and removal of bearings used in BB30 bottom bracket systems. Made from high precision, hardened CroMoly steel the BBT-19.2 can be turned with a 3/8" drive wrench, 1" wrench or Park Tool FRW-1 Freewheel Remover Wrench. Press to press the bearings into the frame. Park Tool BBT-30.3 : Tool Type: For the Garage Features: Miscellaneous: The BBT-30.3 includes a bearing remover, which slides through thebottom bracket shell and into the bearing so it can be tapped out with ahammer. Includes a built-in hook to lift the safety plate found on Hollowtech II crank arms, speeding crank removal.
PRODUCT DESCRIPTION. Included in delivery: 1 BBT-19.2 bottom bracket wrench My recommendation, buy a bike with a threaded bottom bracket, but if you have to get a press fit BB out, this tool will get the job done. A bit pricey for what it does, but since it has worked every time I have used it and not caused damage to the bearings I am not complaining. Includes bearing removal tool and two bushings, which when used in conjunction with the Park Tool Bearing Cup Press, will press the bearings into the frame. Anyways this handy tool allows you to tap out the bearings on your press fit frame and in a way that (if you are careful) does not damage the bearing like more creative methods might. The BBT-90.3 tool set includes a bearing removal tool, which slides through and expands behind the bearing (like a head cup remover) so it can be tapped out with a hammer. It comes with two adaptors depending on the BB you have, and especially if you work in a shop setting is the way to go. If you have a press fit bottom bracket you are probably going to need to replace it at some point. The Park Tool BBT-10.2 is a specialty tool for removing and installing crank caps on Shimano Hollowtech II cranks. Use the bushing in conjunction with an HHP-2 or HHP-3 Bearing Cup. The BBT-30.3 set also includes installation cups to be used in conjunction with the Park Tool HHP-1, 2 or 3 Headset Cup Press to quickly and precisely press the bearings into the bottom bracket shell Made in the USA and covered by Park Tool's legendary limited lifetime warranty Not saying that press fit BBs are bad… actually yes I am saying that haha. Tools designed by Park Tool to service Bottom Brackets.