It is perfect for studio vocals, just like a condenser, but it is a slightly different mic.
You can bang the desk and move the mic around and you won’t pickup any unwanted sounds.The Shure SM7B can be used without additional shock mounts or pop filters, whereas the Rode NT1 requires a separate shock mount and pop filter to improve sound quality.
Acoustically, both mics perform almost identically. If the artist got a huge dynamic range, the sm7b can handle this very good, i think.
Condenser performance in a dynamic mic. Both microphones are XLR mics and have a cardioid pickup pattern, which means they only record sound from the front of the mic.You can use the Shure SM7B without a preamp, but adding gain can be helpful if you’re going to be recording speech (i.e.
There are instructions in the manual to help you change the setup for a vertical microphone stand.
The SM7B is used by voice over artists .
Most podcasters and voice over artists typically get much closer than 3 inches, particularly if they are using the close-talk windscreen, so you will do fine with less than 60dB gain.Low impedance allows for very long cable runs without sound degradation.The Shure SM7B is also popular with radio stations. For singing or recording loud instruments, you could manage without.In simple terms, if you speak normally into an SM7B mic with your lips on the foam (which is around 1 Pascal), you’ll get output of 1.12 mV, which equates to a signal level of about -59dBV (decibels).You can use Shure’s SM7B with or without the optional windscreens attached. Remove the fitted washers, the lock washers, the outer brass washers, and the brass sleeves.
Choose from 3 pickup patterns (cardioid, omnidirectional and figure 8) to record in different scenarios. All dynamic microphones will pick up hum to some extent.There are a variety of setups you can choose, but here’s a couple of popular setups that work out-of-the-box:According to Shure, the SM7B is best-suited for:The SM7B comes with a boom mount attachment and is shipped in this configuration.
However, you may find vocal recordings to be too quiet and a preamp can help amplify the signal of your recordings. . The SM7B is a great mic and a keeper, but it may not be what you need at this time. Most people choose to use them, but musician Ben Howard can be seen recording vocals on Shure SM7B mics with the built-in pop shield exposed.Typically, dynamic mics like the SM7B are used for recording loud instruments and singing, but Shure’s top-seller has also become popular with podcasters and voice over artists thanks to its unique sound… if you add some gain (keep reading to find out how).In this review, we break down exactly what you’ll be getting if you buy a Shure SM7B microphone: how it works, who it’s right for, how it performs in different environments, whether you need preamps and, most importantly, how it sounds.Microphone noise can be removed or reduced with post-production, depending on the editing software you use. The Shure SM7B picks up far less background noise than the Rode NT1.You switch between frequency response settings by using a pen or something similar to push the switches on the back of the mic. While most people use the SM7B as a vocal mic, it’s also great at picking up instruments: watch this odd recording session to hear how it performs on a series of brass and wind instruments.
To set up the SM7B in the microphone stand mounting configuration, proceed as follows: Remove tightening nuts on the sides.
Voice over artist Pamela Gregory recording on a Shure SM7B mic. Studio setups and post-production will vary, but, as you will hear, the audio quality is superb in all cases.Listen to (and watch) these musical performances, with vocals recorded on an SM7B:However, if you use the Cloudlifter with a USB audio interface which also has a preamp, you can crank up the gain even further.There are a few accessories and companion products that pair particularly nicely with the Shure SM7B. Here are all the differences you need to know about.The SM7B is an update on Shure’s famous SM7 microphone, which was first introduced in 1976 and became famous as the microphone used to record Michael Jackson’s Thriller album.You’ll also need 2 female to male XLR cables for this setup, and a boom arm or mic stand of your choice.The included switch cover plate is simply a little disc that prevents accidental switching while you’re recording. The Shure SM7B is a great microphone for vocals, and it’s an amazing mic for under $500, so you’re sure to love how easy it is on your wallet and how good the quality is, both of the build and of the sound you’ll get out of it.
podcasts and voice-overs), because the signals you’ll record will need amplifying.